Antweight weapon discs

[Joe (Joe Brown)]

Glad you had good results with super PLA+

Worth mentioning as pointed out in Mark’s post on super PLA+ and also something that’s used in beetles for TPU - number of walls / perimeters is what matters for armour rather than infill:

@MarkR

Note to those new to 3d printing structural parts: infill is not very structural. You will get a lot more strength for the weight with perimeters (x/y surfaces) and top/bottom (z surfaces). Infill is basically a mish-mash of strings which supports the top layers, In some cases it’s possible to use 0% infill, I could probably have done that here and it would be almost the same.